Viconics VT8000 Series Device Replacement Guide Instrukcja Użytkownika Pobierz pdf (Strona 6)

VT8000 Controller Replacement Guide

028-0454-00 www.viconics.com | sales@viconics.com November 2014

6. Mount the front plate on the existing back plate installed on the wall.

NOTE: Ensure small plastic projections at top of front plate align with notches at top of back plate.

7. Push on front plate bottom two corners to secure unit in place (Figure 3).

8. Wait for Room Controller to power up.

9. Use the table on earlier pages to re-conﬁgure your parameters such as sequence of operation, pipe number, occupied

heating/cooling setpoints.

10. Make sure Channel, Pan ID, and Com address match previous settings before replacement to bring Room Controller

back online.

Note: In the event a new ZigBee module is being used instead of the pre-exsisting one, the Room Controller must

be bound to the MPM again.

Figure 3 Secure Unit

1 2 3 4 5 6 7

Brak uwag

Viconics VT8000 Series Device Replacement Guide Instrukcja Użytkownika Strona 6