Viconics VT8000 Series Device Replacement Guide Instrukcja Użytkownika Pobierz pdf (Strona 2)

VT8000 Controller Replacement Guide

028-0454-00 www.viconics.com | sales@viconics.com November 2014

Overview

This procedure shows how to replace VT8000 Series Room Controllers which are already installed and set-up to communicate with a

front end Multi-purpose Manager (MPM) via Zigbee or BACnet.

Use the following table to compare default values with the current parameter conﬁgurations on the VT8300/VT8350 before replacing the

Room Controller. Navigate through the Network, Conﬁguration, and Setpoints/Display pages in the Setup menu and note the current

conﬁgurations if they are different from the default ones. Also, verify you are replacing the Room Controller with the same model.

Object Name Default Conﬁgurations

Current Conﬁgurations

before Replacement

1/2 Zigbee Network

COM Address 254

PAN ID 0

Channel 10

2/2 Zigbee others

Permit Join on

1/2 BACnet Network

COM Address 254

Network Units Imperial

Network Language English

BACnet Baud Rate Auto

1/7 Conﬁguration

BI 1 / UI 16 Status None

BI 2 / UI 17 Status None

RUI 1 / UI 19 Status None

Occupancy Command Local occ.

2/7 Conﬁguration

Auto Mode Enabled

Fan Menu (Sequence) On-Auto

Auto Fan Function AS

Standby Mode Abs

Standby Differential 2 °C ( 3 °F )

3/7 Conﬁguration

Standby Time 0.5H

Unoccupied Time 0H

• When replacing an installed Room Controller, turn off the HVAC

system to prevent any damage by potentially incorrect default

settings on the new Room Controller.

• Electronic controls are static sensitive devices. Discharge

yourself correctly before handling and installing Room Controller.

• Use high caution when installing Room Controller as a short

circuit or incorrect wiring may cause permanent damage to

Room Controller or equipment.

• All VT8000

series Room Controllers controls are designed

for use as operating controls only and are not safety devices.

Tampering with the Device or unintended application of the

Device will result in a void of warranty.

Legend

All models

VT8350 only

Note: ZigBee settings only apply if a ZIgBee

module is installed in Room Controller.

1 2 3 4 5 6 7

Komentarze do niniejszej Instrukcji

Brak uwag

Viconics VT8000 Series Device Replacement Guide Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Dla domu Viconics VT8000 Series Device Replacement Guide